I answered a question recently about a someone’s possible attic space, this is what they wanted to know -> “How much space will I have in my garage attic if it is 25′x25′ and the roof pitch is 6?” I believe this person was trying to put a room in the attic of the garage (not sure if it was for a frog or storage)… Here is how you work out this problem. First when someone says they want a roof pitch of 6 they are saying that the roof rises at 6 inches per foot of travel (approx 27 degrees). We will assume that the garage will have a Gable roof, not a Hip roof (a gable roof is like putting two rectangles at an angle at either side of the building with gables on the other sides, a hip roof would have 4 triangles with the points of the four triangles meeting at the apex of the roof like a 4 sided pyramid – for a square roof).
Split the width of the building in half for easy measurement – 25/2 = 12.5ft. If we want to find the approximate area that will be 8 ft in height we will need to take 12.5 ft run x 6 in (.5ft) rise = 6.25ft. – This means that with this current set-up the garage roof will never reach 8ft. We will have to change the pitch if we want to use this space for a frog (or add a 3-4 foot wall before adding the roof, which would raise the roof). If we change the roof to a 12 pitch (45 degrees), we will reach 8 feet rise in 8 feet of run – this means that we will have 4.5 feet of floor space in 12.5 feet of run (12.5 – 8 = 4.5) and 9 feet in a 25 feet of width. If we take the total length of the gabled roof 25 feet x 9 feet for the width = 425sq ft. This is approximate square feet, it could be more or less depending on framing, usage of areas under 8ft., etc. Remember when you change the pitch to 12, there will be more shingles and more rafter material. Also the roofer will charge you more because 12 pitch is too steep to walk on without some sort of mechanical assistance (usually 2×4 toe boards). Compare price and design with adding 4 feet of wall after the floor level and determine which one fits your budget and house best.

Share on Facebook

Are you planning on a particularly loud room in your house, like a band room or maybe you would like a quiet room for a baby. If you have plans to dampen sound in your house here is how you do it (mostly sound proof, you would still hear dynamite or the drummer for Metallica:).

First thing you are going to want to do is find some sound proofing drywall, this is usually sold at drywall specialty stores. If you live in a small town you may have to visit a nearby city to find this stuff….The other supplies are very easy to find.

The wall is built with 2×6’s for the sole plate and top plate (sole plate ‘bottom’, top plate ‘top’). Place the 2×6’s were you want the wall to be – make sure you make everything square and equidistant from other walls. Use 2×4’s as the wall studs placing them 8 inches and alternating from one side to the other (this will make the 2×4’s 16″ on center on each side of the wall). Weave un-faced fiberglass insulation between the studs horizontally instead of vertically (use R13 insulation or less). Cover the wall with Sound Proof drywall on both sides (one side is ok, both is better depending on the money you have to spend on the project). Then place 1/2″ regular sheetrock on both sides of the wall making sure that you use a different pattern then what you used installing the sound proof wall board (off set the drywall by one stud or start on the other side).

Share on Facebook